 |
Jetwash Powder Detergent -
Material Safety Data Sheet - MSDS
RENEGADE JET WASH POWDER
Document Revision Date: September 24, 2005
SECTION I-GENERAL
|
Trade Name Renegade By |
Service Line
2320 Zinga Drive
Reedsburg, WI 53959
Phone (608) 524-0204
Fax (608) 524-1146 |
|
SECTION II-HAZARDOUS
INGREDIENTS/IDENTITY INFORMATION
Ingredients:
Ingredient Name - (CAS Number) - %
DIETHYLENE GLYCOL MONOBUTYL ETHER (112-34-5) 1.4
SODIUM METASILICATE (6834-92-0) < 50 |
SECTION III-HAZARDS
IDENTIFICATION
Primary Routes(s) Of
Entry: Eye Contact Skin Contact Dust Inhalation
Eye Hazards: Severe irritation, or burns possible.
Skin Hazards: Irritation, or burns possible with
prolonged contact
Ingestion Hazards: Irritation or burns of mouth, throat
or stomach.
Inhalation Hazards: Causes respiratory tract irritation.
Chronic/Carcinogenicity Effects: The product and its
ingredients have not been identified as carcinogen or
probable carcinogen by NTP, IARC monographs or OSHA. |
SECTION IV-FIRST AID MEASURES
Eye: In case of
contact, immediately flush eyes with plenty of water.
Get medical attention immediately. Remove contact
lenses, if worn.
Skin: In case of contact, immediately flush skin with
plenty of water for at least 15 minutes. Get medical
attention immediately if irritation (redness, rash,
blistering) develops and persists.
Ingestion: Give water if swallowed. If swallowed, do not
induce vomiting unless directed to do so by medical
personnel.
Inhalation: If inhaled, remove to fresh air. Get medical
attention if breathing difficulty occurs. |
SECTION V-FIRE FIGHTING
MEASURES
Flash Point: none °F
Autoignition Point: NE °F NE °C
Flammability Class: Non-flammable
Lower Explosive Limit: NE
Upper Explosive Limit: NE
Extinguishing Media
Use the appropriate extinguishing media for the
surrounding fire. |
SECTION VI-ACCIDENTAL RELEASE
MEASURES
|
Avoid runoff to waterways. Collect and dispose. |
SECTION VII-HANDLING AND
STORAGE
Handling And Storage
Precautions
Keep containers tightly closed. Wash thoroughly after
handling. Keep out of reach of children.
Handling Precautions: Avoid breathing dust or solution
spray. Avoid contact with eyes. Do not taste or swallow.
Wash thoroughly after handling. Avoid contact with skin
and clothing.
Storage Precautions: Keep away from acids.
Work/Hygienic Practices: Wash thoroughly after handling. |
SECTION VIII-EXPOSURE CONTROLS
/ PERSONAL PROTECTION
Engineering Controls: Use
with adequate ventilation.
Skin Protection: Chemical-resistant gloves.
Respiratory Protection: None normally required.
Ingredients - Exposure Limits
SODIUM METASILICATE
PQ Corp Recommended Exposure limit- 2 mg/m3 |
SECTION IX-PHYSICAL AND
CHEMICAL PROPERTIES
Appearance: Off-white
powder
Odor: Mild odor
Chemical Type: Mixture
Physical State: Solid
Percent VOCs: 1.4
pH Factor: 11.5 to 12 At a Concentration Of use dilution
Solubility: complete |
SECTION X-STABILITY AND
REACTIVITY
Stability: stable
Hazardous Polymerization: none
Incompatible Materials: Avoid strong oxidizing and
reducing agents. Avoid contact with strong acids. |
SECTION XI-TOXICOLOGICAL
INFORMATION
SECTION XII-ECOLOGICAL
INFORMATION
SECTION XIII-DISPOSAL
CONSIDERATIONS
|
Refer to applicable
federal, state, and local regulations prior to
disposition of container and residual contents. |
SECTION XIV-TRANSPORT
INFORMATION
Proper Shipping Name: use
product name
Freight Class: 55 |
SECTION XV-REGULATORY
INFORMATION
SARA Section 313
Notification
This product contains the following toxic chemicals
subject to the reporting requirements of Section 313 of
the Emergency Planning and Community Right-To-Know Act
of 1986 and of 40 CFR 372. This information must be
included in all MSDSs that are copied and distributed
for this material.
Ingredient(s) - U.S. Regulatory Information
DIETHYLENE GLYCOL MONOBUTYL ETHER
SARA Title III - Section 313 Form "R"/TRI Reportable
Chemical |
SECTION XVI-OTHER INFORMATION
NFPA Rating
Health: 2
Fire: 0
Reactivity: 0
HMIS Rating
Health: 2
Fire: 0
Reactivity: 0 |
DISCLAIMER
The above information is to the
best of our knowledge, current, accurate, and complete based on
information reasonably available to us as of the date of
preparation of this form. However, it is the user's
responsibility to determine the safety, toxicity and suitability
for his or her own use of the product described herein. Since
the actual use by others is beyond our control, no guarantee,
expressed or implied, is made by us to the effects of such use
or on the safety or toxicity of this product. Nor do we assume
any liability arising out of use by others of the product. Nor
is the information herein to be construed as absolutely
complete, since additional information may be necessary or
desirable when exception conditions or circumstances exist or
because of applicable laws or regulations.
|
|
 Service Line part washer products and the
editorial content, graphics, and products of the renegadepartswashers.com
website, unless otherwise noted, are the products of Service Line, Inc..
The information presented on renegadepartswashers.com is copyrighted as
collective work. Any unauthorized reproduction, by any means, mechanical
or electronic, without the express written permission of Service Line,
Inc. is strictly prohibited.
Copyright 2005, 2006 Service Line, Inc.
All rights reserved.
MADE IN THE USA
|
