| |
Brake Cleaner - Material Safety Data
Sheet - MSDS
RENEGADE BRAKE CLEANER
Document Revision Date: January 16, 2012
SECTION I-GENERAL
|
Trade Name Renegade By |
Service Line
2320 Zinga Drive
Reedsburg, WI 53959
Phone (608) 524-0204
Fax (608) 524-1146 |
|
SECTION II-HAZARDOUS
INGREDIENTS/IDENTITY INFORMATION
1 PETROLEUM SOLVENT 85 -
90
2 ALCOHOL 10 - 15
NONE OF THE COMPONENTS OF THIS PRODUCT ARE RECOGNIZED AS
CARCINOGENIC. |
SECTION III-PHYSICAL/CHEMICAL
CHARACTERISTICS
BOILING POINT : 149
(DEGREES F)
evaporation rate: < 1 (ether = 1) % solid : not
applicable
VAPOR DENSITY : > 1 (AIR = 1) WEIGHT PER GALLON : 5.74
(THEORETICAL)
PH LEVEL : SJB
(Boiling point represents boiling point of lowest
boiling raw material.) |
SECTION III-HEALTH HAZARD DATA
- EYE
CONTACT -
BASED ON THE PRESENCE OF COMPONENTS 1 AND 2 PRODUCT IS
PRESUMED TO BE MODERATELY IRRITATING TO THE EYES. BASED
ON THE PRESENCE OF COMPONENTS 1 AND 2 PRODUCT VAPORS
AND/OR MISTS MAY ALSO BE IRRITATING TO THE EYES.
- SKIN CONTACT -
BASED ON THE PRESENCE OF COMPONENT 1 PRODUCT IS PRESUMED
TO BE MODERATELY IRRITATING TO THE SKIN. PROLONGED
CONTACT MAY CAUSE DAMAGE TO THE SKIN. BASED ON THE
PRESENCE OF COMPONENTS 1 AND 2 PROLONGED OR REPEATED
CONTACT MAY RESULT IN DEFATTING AND DRYING OF THE SKIN
WHICH MAY RESULT IN DERMATITIS.
- INHALATION -
EXPOSURE MAY PRODUCE IRRITATION TO THE NOSE, THROAT,
RESPIRATORY TRACT, AND OTHER MUCOUS MEMBRANES. BASED ON
THE PRESENCE OF COMPONENTS 1 AND 2 EXPOSURE TO HIGH
CONCENTRATIONS OF VAPOR MAY PRODUCE CENTRAL NERVOUS
SYSTEM DEPRESSION. BASED ON THE PRESENCE OF COMPONENT 1
REPEATED OVEREXPOSURE MAY DAMAGE THE PERIPHERAL NERVOUS
SYSTEM.
- INGESTION -
BASED ON THE PRESENCE OF COMPONENTS 1 AND 2 PRODUCT IS
PRESUMED TO BE SLIGHTLY TOXIC. BASED ON THE PRESENCE OF
COMPONENT 2 INGESTION MAY CAUSE KIDNEY DAMAGE. BASED ON
THE PRESENCE OF COMPONENT 2 INGESTION MAY CAUSE LIVER
DAMAGE. BASED ON THE PRESENCE OF COMPONENTS 1 AND 2
SMALL AMOUNTS OF THE LIQUID ASPIRATED INTO THE LUNGS
DURING INGESTION OR FROM VOMITING MAY RESULT IN SEVERE
LUNG DAMAGE. BASED ON THE PRESENCE OF COMPONENTS 1 AND 2
INGESTION MAY CAUSE CENTRAL NERVOUS SYSTEM DEPRESSION.
- SIGNS AND SYMPTOMS -
SYMPTOMS OF EYE IRRITATION INCLUDE PAIN, TEARING,
REDDENING AND SWELLING. SYMPTOMS OF SKIN IRRITATION
INCLUDE REDDENING, SWELLING, RASH AND REDNESS. SYMPTOMS
OF RESPIRATORY IRRITATION INCLUDE RUNNY NOSE, SORE
THROAT, COUGHING, CHEST DISCOMFORT, SHORTNESS OF BREATH
AND REDUCED LUNG FUNCTION. SYMPTOMS OF GASTROINTESTIONAL
IRRITATION INCLUDE SORE THROAT, ABDOMINAL PAIN, NAUSEA,
VOMITING AND DIARRHEA. BASED ON THE PRESENCE OF
COMPONENTS 1 AND 2 CENTRAL NERVOUS SYSTEM DEPRESSION MAY
BE EVIDENCED BY HEADACHE, DIZZINESS, NAUSEA AND SYMPTOMS
OF INTOXICATION; IN EXTREME CASES, UNCONSCIOUSNESS AND
DEATH MAY OCCUR. SYMPTOMS OF CHRONIC OVEREXPOSURE
INCLUDE LOSS OF MEMORY, LOSS OF INTELLECTUAL ABILITY AND
LOSS OF COORDINATION.
- AGGRAVATED MEDICAL CONDITIONS -
PREEXISTING SKIN, EYE AND RESPIRATORY DISORDERS MAY BE
AGGRAVATED BY EXPOSURE TO THIS PRODUCT. IMPAIRED CENTRAL
NERVOUS SYSTEM FUNCTIONS FROM PREEXISTING DISORDERS MAY
BE AGGRAVATED BY EXPOSURE TO THIS PRODUCT.
- OTHER HEALTH EFFECTS -
BASED ON THE PRESENCE OF COMPONENT 2 PRODUCT IS PRESUMED
TO BE FETOTOXIC. BASED ON THE PRESENCE OF COMPONENT 2
PRODUCT IS PRESUMED TO BE MUTAGENIC. BASED ON THE
PRESENCE OF COMPONENT 1 CHRONIC OVEREXPOSURE MAY CAUSE
DAMAGE TO THE RED BLOOD CELLS. BASED ON THE PRESENCE OF
COMPONENT 1 REPEATED EXCESSIVE INGESTION MAY CAUSE
CENTRAL NERVOUS EFFECTS. |
SECTION V-EMERGENCY AND
FIRST AID PROCEDURES
- EYE CONTACT -
IMMEDIATELY FLUSH EYES WITH WATER FOR AT LEAST 15
MINUTES. SEEK MEDICAL ATTENTION IF ANY SYMPTOMS PERSIST.
- SKIN CONTACT -
REMOVE CONTAMINATED CLOTHING AND SHOES. WIPE EXCESS FROM
SKIN AND FLUSH WITH WATER USING SOAP IF AVAILABLE. SEEK
MEDICAL ATTENTION IF IRRITATION OCCURS. DO NOT REUSE
CLOTHING UNTIL THOROUGHLY DECONTAMINATED.
- INHALATION -
REMOVE VICTIM TO FRESH AIR AND TREAT SYMPTOMATICALLY.
PROVIDE OXYGEN IF BREATHING IS DIFFICULT. GIVE
ARTIFICIAL RESPIRATION IF THE VICTIM IS NOT BREATHING.
SEEK PROMPT MEDICAL ATTENTION.
- INGESTION -
DO NOT INDUCE VOMITING. IF VOMITING SPONTANEOUSLY
OCCURS, KEEP THE VICTIM'S HEAD BELOW THE HIPS TO PREVENT
ASPIRATION INTO THE LUNGS. SINCE ASPIRATION INTO THE
LUNGS CAN CAUSE VERY SERIOUS, PERMANENT DAMAGE, THE
DECISION OF WHETHER TO INDUCE VOMITING OR NOT SHOULD BE
MADE BY A PHYSICIAN. DANGER FROM LUNG ASPIRATION MUST BE
WEIGHED AGAINST TOXICITY WHEN CONSIDERING EMPTYING THE
STOMACH. CONSULT A PHYSICIAN, HOSPITAL OR POISON CONTROL
CENTER AND/OR TRANSPORT TO AN EMERGENCY FACILITY
IMMEDIATELY.
- NOTES FOR PHYSICIAN -
THE FOLLOWING COMPONENT-SPECIFIC INFORMATION MAY CONTAIN
CONTRADICTIONS, AND IS INTENTIONALLY INCLUDED TO GIVE
THE ATTENDING PHYSICIAN SPECIFIC INFORMATION ABOUT THE
INDIVIDUAL COMPONENTS OF THE BLEND. >> COMPONENTS 1 AND
2 MAY CAUSE SEVERE, PERMANENT DAMAGE IF ASPIRATED AND
VOMITING SHOULD NOT BE INDUCED. |
SECTION VI– FIRE AND
EXPLOSION HAZARDS
FLASH POINT : -25 DEGREES
F. TCC
- EXTINGUISHING MEDIA -
USE WATER FOG, FOAM, DRY CHEMICAL OR CARBON DIOXIDE.
- SPECIAL FIRE FIGHTING PROCEDURES AND PRECAUTIONS -
WARNING. EXTREMELY FLAMMABLE. CLEAR FIRE AREA OF
UNPROTECTED PERSONNEL. DO NOT ENTER CONFINED FIRE SPACE
WITHOUT HELMET, FACE SHIELD, BUNKER COAT, GLOVES, RUBBER
BOOTS, AND A POSITIVE PRESSURE NIOSH-APPROVED
SELF-CONTAINED BREATHING APPARATUS.
- UNUSUAL FIRE AND EXPLOSION HAZARDS -
CONTAINERS EXPOSED TO INTENSE HEAT FROM FIRES SHOULD BE
COOLED WITH WATER TO PREVENT VAPOR PRESSURE BUILDUP
WHICH COULD RESULT IN CONTAINER RUPTURE. CONTAINERS THAT
ARE EXPOSED TO DIRECT FLAME SHOULD BE COOLED WITH WATER
TO ELIMINATE STRUCTURAL WEAKENING OF THE CONTAINER'S
WALL AND POSSIBLE RUPTURE. |
SECTION VII-REACTIVITY
STABILITY : STABLE
HAZARDOUS POLYMERIZATION : WILL NOT OCCUR - CONDITIONS
AND MATERIALS TO AVOID -
- HAZARDOUS DECOMPOSITION PRODUCTS -
CARBON DIOXIDE, CARBON MONOXIDE AND UNIDENTIFIED ORGANIC
COMPOUNDS MAY BE FORMED DURING COMBUSTION. |
SECTION VIII-EMPLOYEE
PROTECTION
- RESPIRATORY PROTECTION -
USE VENTILATION AS REQUIRED TO CONTROL VAPOR
CONCENTRATIONS - AT LEAST 10 AIR CHANGES PER HOUR ARE
RECOMMENDED FOR GOOD GENERAL ROOM VENTILATION. IF
EXPOSURE EXCEEDS THE PEL/TLV, USE THE APPROPRIATE NIOSH-APPROVED
RESPIRATOR.
- PROTECTIVE CLOTHING -
WEAR SAFTEY GLASSES, GOGGLES, OR A SPLASH SHIELD TO
PREVENT EYE CONTACT. CONTACT LENSES SHOULD NOT BE WORN.
WEAR APPROPRIATE GLOVES AND PROTECTIVE CLOTHING TO
PREVENT CONTACT WITH SKIN AND CLOTHING.
- ADDITIONAL PROTECTIVE MEASURES -
EYE WASH FOUNTAINS AND SAFETY SHOWERS SHOULD BE
AVAILABLE FOR USE IN AN EMERGENCY. |
SECTION IX- ENVIRONMENTAL
PROTECTION
- SPILL OR LEAK PROCEDURES
-
LARGE SPILLS >> EVACUATE THE HAZARD AREA OF UNPROTECTED
PERSONNEL. WEAR APPROPRIATE RESPIRATOR AND PROTECTIVE
CLOTHING. SHUT OFF SOURCE OF LEAK ONLY IF SAFE TO DO SO.
DIKE AND CONTAIN. IF VAPOR CLOUD FORMS, WATER FOG MAY BE
USED TO SUPPRESS; CONTAIN RUN-OFF. REMOVE WITH VACUUM
TRUCKS OR PUMP TO STORAGE/SALVAGE VESSELS. SOAK UP
RESIDUE WITH AN ABSORBENT SUCH AS CLAY, SAND OR OTHER
SUITABLE MATERIAL; PLACE IN NON-LEAKING CONTAINERS FOR
PROPER DISPOSAL. FLUSH AREA WITH WATER TO REMOVE TRACE
RESIDUE; DISPOSE OF FLUSH SOLUTIONS AS ABOVE. SMALL
SPILLS >> TAKE UP WITH AN ABSORBENT MATERIAL AND PLACE
IN NON-LEAKING CONTAINERS; SEAL TIGHTLY FOR PROPER
DISPOSAL.
- WASTE DISPOSAL -
OBSERVE ALL FEDERAL, STATE, AND LOCAL REGULATIONS
REGARDING PROPER DISPOSAL. |
SECTION X-ADDITIONAL
PRECAUTIONS
| KEEP LIQUID AND VAPOR AWAY
FROM HEAT, SPARKS, AND FLAME. EXTINGUISH PILOT LIGHTS,
CIGARETTES AND TURN OFF OTHER POSSIBLE SOURCES OF
IGNITION PRIOR TO USE AND UNTIL VAPORS ARE GONE.
SURFACES THAT ARE SUFFICIENTLY HOT MAY IGNITE PRODUCT IN
THE ABSENCE OF SPARKS OR FLAME. VAPORS MAY ACCUMULATE
AND TRAVEL TO IGNITION SOURCES DISTANT FROM HANDLING
SITE. KEEP CONTAINERS CLOSED WHEN NOT IN USE. USE WITH
ADEQUATE VENTILATION. CONTAINERS, EVEN IF EMPTY, CAN
CONTAIN EXPLOSIVE VAPORS OR RESIDUES. DO NOT CUT, DRILL,
GRIND, OR WELD NEAR CONTAINERS AFTER CONTACT WITH
PRODUCT OR CONTAINER WASH WITH SOAP AND WATER BEFORE
EATING, DRINKING, SMOKING, OR USING TOILET FACILITIES. |
DISCLAIMER
This information relates to
the specific material designated and may not be valid for such
material used in combination with any other materials or in any
process.
Such information is to the best of our knowledge and belief,
accurate and reliable as of the date compiled. However, no
representation, warranty or guarantee is made as to its
accuracy, reliability or completeness. It is the users
responsibility to satisfy himself as to the suitability and
completeness of such information for his own particular use. We
do not accept liability for and loss or damage that may occur
from the use of this information nor do we offer warranty
against patent infringement.
|
|
